スペース
Home | On-Line Catalog | Scale Models | R/C Models | Mini 4WD

How to Program DMD Control Unit T-03

It is necessary to program the DMD Control Unit T-03 if it is used together with something other than Tamiya ATTACK 4WD or Futaba 4-channel transmitters. In this case, switch on the transmitter, set all trims to neutral, then follow the steps below.

 1. Resetting DMD Control Unit T-03


Switch the unit on and LED will flash green. Press the Set Button and the LED will switch to a red, orange, then green flashing pattern to indicate unit reset.

 2. Programming Left Control Stick's Forward/Rearward Movement


Move control stick from neutral position to maximum forward, then maximum rearward positions.
LEDs will flash as shown.

 3. Programming Right Control Stick's Left/Right Movement

Move control stick from neutral position to maximum right, then maximum left positions.
LEDs will flash as shown.

 4. Programming Right Control Stick's Forward/Rearward Movement

Move control stick from neutral position to maximum forward, then maximum rearward positions.
LEDs will flash as shown.

 5. Programming Left Control Stick's Left/Right Movement

Move control stick from neutral position to maximum right, then maximum left positions. After conducting Steps 2 through 5, LED will flash green and programming is complete. The movement range of each control stick is then stored.

 6. Programming Complete

Press the Set Button once more and LEDs will flash green to indicate programming completion.

Return to DMD Control Unit Page.

スペース

Home | On-Line Catalog | Scale Models | R/C Models | Mini 4WD